Table of Contents
Advertisement
Pan/Tilt Control
(Program Preset Position)
The following function requires the use of cameras
equipped with this specific feature.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Move the camera to the position to be preset by mov-
ing the Joystick Controller and pressing the lens control
buttons.
3. Select the desired preset position number by pressing
the numeric buttons.
4. Holding down the [PROGRAM PRESET] button, and
then press the [CAMERA (ENTER)] button to save a
preset position of the selected camera.
Note: If the position number entered has been stored
previously, the old position will be overwritten by
the new one.
105
PROGRAM
PRESET
T&D
CAM ID
GEN
AUX1 OFF
AUX1 ON
WIPER
ALM S
VLD S
SYS S
MON STATUS
ALL
CALL
PRESET
AUX2 OFF
AUX2 ON
ALM H
VDL H
DEF OFF
DEF ON
CLEAR
CAMERA
( ESC )
( ENTER )
SHIFT
BLK
EXIT
AUTO
PAN
Pan/Tilt Control (Call Preset Position)
The following function requires the use of cameras
equipped with this specific feature.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Select the preset position number by pressing the
numeric buttons.
3. Press the [CALL PRESET] button to move to the pre-
set position of the selected camera on the active moni-
tor.
T&D
CAM ID
AUX1 OFF
AUX1 ON
ALM S
VLD S
MON STATUS
AUX2 OFF
AUX2 ON
ALM H
VDL H
DEF OFF
DEF ON
SHIFT
BLK
Note: To be able to use the above function, the preset
position number must have been set for that cam-
era.
PROGRAM
PRESET
GEN
WIPER
SYS S
ALL
CALL
PRESET
CLEAR
CAMERA
( ESC )
( ENTER )
EXIT
AUTO
PAN
Advertisement
Table of Contents
