Table of Contents
Advertisement
Group Sequence
The following function is available only if a Group Sequence
has been previously established through the Administration
Console.
1. As described earlier, a Group Sequence determines
which monitor is to be assigned to which camera.
Therefore, selecting a monitor is not required.
2. Select a desired Group Sequence Number by pressing
the Numeric buttons.
3. Press the [GROUP SEQ] button to run a Group
Sequence forward on the assigned monitors.
The selected Group Sequence Number (G4) with "R"
sign (indicate running status) is displayed on the active
monitors.
PREV
S-CTL ID
PAUSE
CAM MENU OFF
CAM MENU ON
GROUP
SEQ
OSD
4. To pause the sequence, select one of the monitors that
are being run on the selected group sequence, then
press the [PAUSE] button.
The "P" sign (indicating the pause status) is displayed
at the Group Sequence Number on the assigned moni-
tor.
5. Press the [GROUP SEQ] button to restart a Group
Sequence forward from the next step that was previ-
ously paused by pressing the PAUSE button.
6. Press the [NEXT] button to move the sequence one
frame to the next step from the step that was previously
paused by pressing the PAUSE button.
7. Press the [PREV] button to move the sequence one
frame to the previous step from the step that was previ-
ously paused by pressing the PAUSE button.
8. To stop the sequence, select one of the monitors that
are being run on the selected group sequence, then
press the [STOP] button.
111
NEXT
T&D
CAM ID
GEN
AUX1 OFF
AUX1 ON
WIPER
ALM S
VLD S
SYS S
STOP
MON STATUS
ALL
AUX2 OFF
AUX2 ON
ALM H
VDL H
TOUR
SEQ
DEF OFF
DEF ON
CLEAR
( ESC )
MONITOR
SHIFT
BLK
EXIT
LOCK
OSD SERVICE
Advertisement
Table of Contents
