Figure 15 Ip Settings (Bridge) - Korenix JetWave 2450 Series User Manual

IP Settings (Bridge)
This is available only under Bridge network mode. Open "IP Settings (Bridge)" in "System" as
below to configure the parameters for LAN which connects to the LAN port of JetWave 2450. In
this page, users may change the settings for IP Address, Subnet Mask, and DHCP Server.
Obtain IP Address Automatically: If a DHCP server exists in your network, you can check this
option, thus the JetWave 2450 is able to obtain IP settings automatically from that DHCP server.
Use Fixed IP Address: Check this option. You have to specify a static IP address, subnet mask,
default gateway and DNS server for JetWave 2450 manually. Make sure the specified IP address
is unique on your network in order to prevent IP conflict.
IP Settings (Router)
This is available only under Router mode. Open "IP Settings (Router)" in "System" as below to
configure the parameters of JetWave 2450 for accessing the Internet.
Chapter 3 Basic Settings

Figure 15 IP Settings (Bridge)

Page 17