Configure Snmpv3 User Profile; Figure 32 Configure Snmpv3 User Profile - Korenix JetWave 2450 Series User Manual

Set Community
Specify the password for the incoming Set requests from the management station. By default, it is
set to private.
Trap Destination
Specify the IP address of the station to send the SNMP traps to.
Trap Community
Specify the password sent with each trap to the manager. By default, it is set to public and allows all
requests.

Configure SNMPv3 User Profile

For SNMP protocol version 3, you can click "Configure SNMPv3 User Profile" in blue to set the details
of SNMPv3 user. Check "Enable SNMPv3 Admin/User" in advance and make further configuration.
User Name
Specify a user name for the SNMPv3 administrator or user. Only the SNMP commands carrying this
user name are allowed to access the JetWave 2450.
Chapter 5 Management

Figure 32 Configure SNMPv3 User Profile

Page 35