Korenix JetWave 2450 Series User Manual page 28

WAN Settings: Specify the Internet access method to Static IP, DHCP or PPPOE. Users must
enter WAN IP Address, Subnet Mask, Gateway settings provided by your ISPs.
LAN Settings: When DHCP Server is disabled, users can specify IP address and subnet mask
for JetWave 2450 manually. Make sure the specified IP address is unique on your network in
order to prevent IP conflict. When DHCP Server is enabled, users may specify DHCP IP Address
Range, DHCP Subnet Mask, DHCP Gateway and Lease Time (15-44640 minutes).
Warning:
In AP mode, JetWave 2450 must establish connection with another wireless device
before it is set to Router mode. In Router mode, it is impossible for users to access
device via wired port, for WAN is on wired port and LAN is on wireless port. Users can
access device through the wireless device connected with JetWave 2450.
In CPE mode, users can access JetWave 2450 via its wired port, for WAN is on
wireless port and LAN is on wired port when device is set to Router mode.
Bridge mode and AP Repeater mode are similar to AP mode when device is set to
Router mode; WAN is on wired port and LAN is on wireless port. Thus users must also
connect JetWave 2450 with another wireless device before it is set to Router mode
and access JetWave 2450 via the connected wireless device.
Chapter 3 Basic Settings
Figure 16 IP Settings (Router)
Page 18