Basic Wireless Settings
Open "Basic Settings" in "Wireless" as below to make basic wireless configuration.
Disable Wireless LAN Interface
Check this option to disable WLAN interface, then the wireless module of JetWave 2450 will stop
working and no wireless device can connect to it.
Wireless Mode
Four operating modes are available on JetWave 2450.
Wireless Client: The JetWave 2450 is able to connect to the AP and thus join the wireless
network around it.
AP: The JetWave 2450 establishes a wireless coverage and receives connectivity from other
wireless devices.
Bridge: The JetWave 2450 establishes wireless connectivity with other APs by key-in remote
MAC address .If necessary, please refer to the "WDS Setting".
AP Repeater: The JetWave 2450 servers as AP and Bridge at the same time. In other words, the
JetWave 2450 can provide connectivity services for CPEs under WDS mode.
Chapter 3 Basic Settings
Figure 25 Basic Wireless Settings
Page 24