Using The External Antenna; Figure 11 Move The Rubber - Korenix JetWave 2450 Series User Manual

Using the External Antenna

If you prefer to use the external antenna with N-type connector for your application instead of the
built-in directional antenna, please follow the steps below.
1. Grab the black rubber on the top of JetWave 2450, and slightly pull it up. The metal N-type
connector will appear.
2. Connect your antenna with the N-type connector on the top of JetWave 2450.
Note:
If you are going to use an external antenna on JetWave 2450, get some cable in
advance.
Be aware of the force you use while connecting to the N-type connector, inappropriate
force may damage the N-type connector!
Warning:
Users MUST power the JetWave 2450 off first before connecting the external antenna
to it; otherwise, damage might be caused to the JetWave 2450 itself.
Chapter 2 Hardware Installation

Figure 11 Move the Rubber

Page 12