Basic System Settings; Figure 14 Basic System Settings - Korenix JetWave 2450 Series User Manual

Basic System Settings

For users who use the JetWave 2450 for the first time, it is recommended that you begin configuration
from "Basic Settings" in "System" shown below:
Basic Settings
Ethernet DataRate: Adjust the data rate of Ethernet connection, including 10/100M full-duplex,
half-duplex and Auto.
Network Mode: Specify the network mode, including Bridge and Router. It is easy to configure
parameters in Bridge Mode; however, users must pay extra attention to the way they configure the
device when it is set to Router Mode. For details, please refer to "IP Settings (Router)".
Device Name: Specify the device name, which is composed of no more than 15 characters with
(0-9), (A-Z), (a-z) or (-).
Country Region: The availability of some specific channels and/or operational frequency bands
is country dependent.
Spanning Tree: Spanning Tree Protocol (STP) is a link management protocol for AP which
provides path redundancy while preventing loops in a network. STP allows only one active path
at a time between the access points but establish the redundant link as a backup if the initial link
fails.
STP Forward delay: Enter a value between 1 and 30 seconds. This value is the time that a port
waits before changing from Spanning Tree Protocol learning and listening states to forwarding
state.
Chapter 3 Basic Settings

Figure 14 Basic System Settings

Page 16