Password; Figure 33 Password - Korenix JetWave 2450 Series User Manual

Password

Specify a password for the SNMPv3 administrator or user. Only the SNMP commands carrying this
password are allowed to access the JetWave 2450.
Confirm Password
Input that password again to make sure it is your desired one.
Access Type
Select "Read Only" or "Read and Write" accordingly.
Authentication Protocol
Select an authentication algorithm. SHA authentication is stronger than MD5 but is slower.
Privacy Protocol
Specify the encryption method for SNMP communication. None, DES and None are available.
None: No encryption is applied.
DES: Data Encryption Standard, it applies a 58-bit key to each 64-bit block of data.
Password
From "Password Settings" in "Management", you can change the password to manage your JetWave
2450. Enter the new password respectively in "New Password" and "Confirm Password" fields; click
"Apply" to save settings.
Note:
The password is case-sensitive and its length can not exceed 19 characters!
Chapter 5 Management

Figure 33 Password

Page 36