Site Survey; Figure 26 Site Survey - Korenix JetWave 2450 Series User Manual

Data Rate
Usually "Auto" is preferred. Under this rate, the JetWave 2450 will automatically select the highest
available rate to transmit. In some cases, however, like where there is no great demand for speed,
you can have a relatively-low transmit rate for compromise of a long distance.
Channel Mode
Two levels are available: 20MHz and 40MHz. The latter one can enhance the data rate more
effectively, but takes more bandwidth, thus cause potential interference.
Extension Channel Protection Mode
This is to avoid conflict with other wireless network and boost the ability of your device to catch all
802.11g transmissions. However, it may decrease wireless network performance. Compared to
CTS-Self; the transmission amount of CTS-RTS is much lower.
Enable MAC Clone
Available only under wireless client mode, it hides the MAC address of the AP while displays the
one of associated wireless client or the MAC address designated manually.

Site Survey

Under wireless client mode, the JetWave 2450 is able to perform site survey, through which,
information on the available access points will be detected.
Open "Basic Settings" in "Wireless", by clicking the "Site Survey" button beside "Wireless Mode"
option, the wireless site survey window will popup with a list of available wireless networks around.
Select the AP you would like to connect and click "Selected" to establish connection. The wireless site
survey window can also be viewed by opening the "Site Survey" page in "Tools".
Chapter 3 Basic Settings

Figure 26 Site Survey

Page 26