Spirit MT200 User Manual page 7

Leveling the MT200:
Once the MT200 is assembled, and placed on a flat level floor, it may be necessary to
•
adjust the four leveling glides on the bottom of the rear incline unit to ensure proper stability
of the MT200. Use a 1/2" wrench to loosen the top nut of the leveler. Adjust the levelers by
hand as necessary to remove any wobble in the unit. Then tighten the top nut against the
bottom of the stabilizer tube. Make sure the bottom nut remains cinched against the
leveling foot.
Connecting to A.C. Power:
The MT200 A.C. mains input is located in the front of the unit. The input module has an
•
input connector for the line cord, a power switch and a 20 amp circuit breaker. Turn the
power switch to off when the MT200 is not in use.
Hand Rail Adjustments
Vertical Adjustment
Adjusting the hand rail vertical position:
To Lift: Turn both the left and right knobs counter clockwise one or two rotations. Then just
•
grab the lift bar and pull up. The locking pins in the knobs will automatically ratchet into the
indexing holes in the tubes. Tighten the knobs when desired position is set. There is a
numbered scale on the tubes for repeatable settings.
To Lower: Loosen the two knobs and then pull them out and rotate slightly until the knob
•
remains out on its own. The pin should now be disengaged from the tube and you can use
the lift bar to lower the rails. Lower the rail past the position you desire and rotate the knob
again so the pin can engage the holes in the tube. Now lift the rails to the desired position
and lock the knob.
Adjusting the hand rail horizontal position:
Turn both the left and right levers counter clockwise one rotation. Move the rails to the
•
desired position and re-lock the levers. There are numbered scales on the tubes for
repeatable settings. The levers may be blocked by the rotating tube when position is
changed. The levers can be repositioned by pulling out and rotating them to a new position,
allowing tightening.
Horizontal Adjustment
6
Lift Bar
MT200