Table of Contents
Advertisement
Step 1: Upright Tubes
• The right side upright tube (19) has the computer cables pre-installed. Lift the tube off the
walking surface and attach it to the base frame. You need to gently pull on the computer
cables as you align the upright tube into the bracket on the base frame, taking the slack out
so the cable does not get pinched between the tube and the base frame. Assemble one
3/8" x 3-3/4" bolt (104), 3/8" split washer (58) and 3/8" flat washer (59) through the top hole
in the retaining plate (21), and corresponding top hole in the upright tube, and screw into
the base frame. Now install the other two bolts (104) and washers (58 & 59) and hand
tighten all three. Do not torque the bolts yet until the upper console frame is installed.
• Install the left upright (18) in the same manner.
22
MT200
Advertisement
Table of Contents
