Table of Contents
Advertisement
Maintenance Menu in console software:
The console has built in maintenance/diagnostic software. The software will allow you to change
the console settings from English to Metric and turn off the beeping of the speaker when a key is
pressed for example. To enter the Maintenance menu (may be called Engineering mode,
depending on version) press and hold down the Start, Stop and Enter keys. Keep holding the keys
down for about 5 seconds and the message window will display "Engineering mode". Press the
enter button to access the menu below:
1. Maintenance Mode
a. Press and hold the Start, Stop and Enter key at the same time, until the display shows
"ENGINEERING MODE" (it may say maintenance menu, depending on version). Press
the Enter key. You can now scroll through the menu using the up and down keys. Use
the Stop key to return to previous menu selection. The menu selections are:
b. Key Test – Press each key to verify it is functioning correctly
c. Display test - Lights all LED lights
d. Functions
i. Sleep - Turns SLEEP MODE ON or OFF. When off, display power is always on.
ii. Pause - Turns PAUSE MODE ON or OFF. When on, Pause lasts 30 minutes.
iii. Odometer reset - Reset odometer readings
iv. Units - Set display to ENGLISH or METRIC readings
v. Grade Return (GS Mode) - Turns GS MODE ON or OFF. Returns the elevation
to lowest setting when pause is pressed
vi. Beep – Turns the speaker (beep sound) on or off.
vii. Service Mode:
1. Incline
a. MW scrolls: "USE INCLINE KEYS FOR FRONT USE SPEED
KEYS FOR REAR" then switch to VR display below.
b. Incline keys operate front motor, speed keys operate rear motor.
Hold down up/down key to operate motor, stop when key is
released. Motor is allowed to move until limit switch activated.
c. MW displays A/D values for both position sensors. Example of the
readings F 920 R 70. F=Front incline sensor and R = Rear incline
sensor. The readings will be opposite: when at lowest incline the
front will show a large number and rear will be small.
2. Drive Motor
a. MW displays: "USE SPEED KEYS TO MOVE MOTOR". Each key
press increases motor speed 0.1 mph/kph
b. MW then shows: RPM 000 AMP 00.0. The sensor reading indicates
motor RPM, not belt speed. The AMP is measuring Motor current
3. Motor Brake
a. Brake ON (brake coil turned off) (User press enter to turn Brake
OFF)
4. Step Sensors
a. Test
i. Use sensor outputs to light DM similar to Symmetry display.
This test is only to make sure the sensors are functioning
and does not test accuracy. The DM graph shows left and
right sensor activity when stepping on the deck. Both sides
of the graph will light at the same time, but the side the user
steps with would show more segments lit.
35
MT200
Advertisement
Table of Contents
