Table of Contents
Advertisement
e. Acceleration Key Lock –MW show "ACCEL KEY", press enter then MW shows
"ACCEL LOCKED". This is the default. If the user presses the up or down key the MW
shows "ACCEL UNLOCKED". Press enter to exit.
f. Speed limit setting –MW shows "SPEED LIMIT", press enter. The MW shows Limit
10.0 MPH. This is the default setting and is the top forward speed of the treadmill.
i. If the user presses the down key the MW shows Limit 9.9 MPH. The top limit can
be changed in 0.1 MPH increments.
ii. The minimum speed limit setting is 3.0 mph.
g. Security –MW show "SECURITY" MW shows "CHILD LOCK ON " or OFF , Sets the
Child Lock function. This function locks out the keypad until a pre-determined key
sequence is pressed. Key sequence = Start & Enter held down together until unlocked.
2. Factory and Acceleration Settings
a. Enter the Factory settings; press Start and Speed Fast keys while console is in power
up reset. User presses enter
i. UNITS: ENGLISH
ii. ADJUST MIN SPEED THEN PRESS ENTER
iii. ADJUST MAX SPEED THEN PRESS ENTER
iv. ADJUST REVERSE SPEED MAX THEN PRESS ENTER
v. ADJUST BELT SPEED ACCELERATION TIME PER EACH 1.0 MPH
vi. ADJUST BELT SPEED DECELERATION TIME PER EACH 1.0 MPH
vii. Press Enter for Grade Calibration Or To Exit Hold Stop Key Until Reset.
viii. Adjust Max Incline Then Press Enter
ix. Adjust Max Decline Then Press Start to calibrate
x. If Grade calibration is successful the MW shows "Passed" for 3 seconds then exit
to idle mode.
b. Calibration
i. MW: START LEFT SIDE
ii. When Start is pressed the MW shows: AD _ _ _ TGT 65
iii. Speaker will beep slowly when magnet distance is too far,
quickly when near and steady when correct.
iv. Press enter to continue
v. MW: START RIGHT SIDE
vi. When Start is pressed the MW shows: AD _ _ _ TGT 65
vii. Speaker will beep slowly when magnet distance is too far,
quickly when near and steady when correct.
viii. User press enter or stop to end calibration
1. The default setting is English. User can press any up/down arrows to
change to Metric. User presses enter.
1. Default value is 0.1 mph and can be adjusted up to 0.5mph.
2. The speed number to be shown in the speed window.
1. Default value is 10.0 mph and can be adjusted down to 3.0 mph.
2. The speed number to be shown in the speed window
1. Default value is 3.0 mph and can be adjusted down to 1.0 mph and up to
5.0 mph.
1. The default is 0:03 seconds and will be shown in the Time window.
2. The time can be adjusted down to 0:01 and up to 1:00 minute
1. The default is 0:03 seconds and will be shown in the Time window.
2. The time can be adjusted down to 0:01 and up to 1:00 minute
1. The default value is 15 and can be adjusted down to 10
1. The default value is 5 and can be adjusted up to 10
36
MT200
Advertisement
Table of Contents
