Table of Contents
Advertisement
2. Press and hold the OSD key on the remote keypad for 2‐3 seconds, then press the menu key.
5.6 Ethernet
5.6.1 Trouble Establishing Communication with Projector
1. Insure any address changes have been saved, and reboot to implement. If you still have trouble establishing
communications with a projector added to an existing Ethernet network, the projector IP address is likely in
conflict with another address already in use. Contact your network administrator.
2. Insure Ethernet settings are valid for the site. All devices should have the same subnet mask yet unique IP
addresses.
5.7 Displays
5.7.1 The projector is on but there is no display
1. Has a lens cover been accidently left on? Remove lens cover.
2. On the LCD display, check that the shutter is open. This will also be indicated by the shutter LED being green.
3. Is the correct input selected. Check cable connections.
4. Check if menus appear on the screen.
5. Can you access test pattern? Insure a full black test pattern has not been selected for display, press Menu to
access test patterns, then cycle patterns with keys. Check your source connections again.
5.7.2 Severe Motion Artifacts
1. Most likely there is a synchronization problem with reversed 3‐2 pull‐down in 60Hz‐to‐24Hz film‐to¬digital
conversion in your source. Correct at the source.
2. Set the projector to run in Free run. Open OSD menu and go to Input Switching & PIP. Insure that running mode
is set to Free run not to Frame Lock.
3. Display a test pattern on the screen, pressing the Test button on the remote keypad. The test pattern should be
displayed correctly. If not, contact your dealer for assistance.
5.7.3 Image Appears 'Squeezed' or Vertically Stretched into Center of Screen
83
Advertisement
Table of Contents
