Table of Contents
Advertisement
2. Align the new lens interface plate with the lens mount. Align the
lens electrical connector with the mating connector on the lens mount.
Fully insert the assembly straight into the lens mount opening without
turning. Press using your hand as shown in Figure 4‐6.
NOTE: Insure the lens is not inserted at an angle, as this can cause
damage.
3. While holding the lens flat against the lens mount, rotate the lens clamp clockwise to lock the lens assembly in
place. See Figure 4‐7.
FIGURE 4‐7
4. Remove the front lens cap.
5. For added stability such as motion applications, fasten the security screws provided with the lens mount. See
Figure 4‐8.
FIGURE 4‐6
FIGURE 4‐8
FIGURE 4‐8
77
Advertisement
Table of Contents
