Wolf cinema REF-700 Owner's Manual page 12

Home theater projectors
Table of Contents

Advertisement

The REF projector series operates most efficiently with ambient room temperature air flowing into the intake line;  
as such it is not necessary to tie the intake line into the residential HVAC system.  
Use care to insure that the intake and exhaust lines are not "kinked" or otherwise blocked in the final installation. 
At periodic intervals, perform a temperature systems check of the projector.  Select the "Status" option on the 
Main Menu and review the available internal operating temperatures.  Wolf Cinema REFERENCE series projectors 
successfully operate in the 40‐50 degree Celsius ranges, maintaining cool air flow over all key components. Should 
you experience operating temperatures beyond that [i.e., above the mid‐60 degree ranges]: 
Prepare to power down the projector, but first quickly check the external fan assembly – is it on and 
working properly?   Is the AC voltage block working to deliver current to the fan?  Insure that hot air is 
being properly extracted from the projector.   
If the external fan is working then power down the projector and review other elements of your installation: 
Check for blockage in the intake or exhaust lines – are there kinks in the lines restricting air flow? 
Check the external ductwork assemblies – have they slipped off the projector or fan attachment ports? 
Step 2 – Installing the Projection Lens  
The projection lens, shipped separately from the projector, must be installed prior to setting up the projector.  
IMPORTANT!  
The lens seals the projector, preventing contaminants from entering the interior of the projector. 
Never operate a projector without a lens.  
IMPORTANT!  
Remove the rear lens cap from the lens. Keep the front lens cap on the lens to protect it during 
installation.  
1. Rotate the lens clamp to the OPEN position, as indicated below in Figure 2.3: 
 
 
 
 
 
 
Remove the lens plug from the lens opening in the projector before installing 
the lens.  
Retain the lens plug for projector transportation to protect the optical 
components from dust and debris.  
 
 
12 

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ref-1000

Table of Contents