Wolf cinema REF-700 Owner's Manual page 79

Home theater projectors
Table of Contents

Advertisement

• 
Operate the projector at the specific voltage only. Do not overload power outlets and extension cords as 
this can result in fire or shock hazards.  
• 
The projector is equipped with a 3‐wire plug having a third (grounding) pin. This is a safety feature. If you 
are unable to insert the plug into the outlet, contact and electrician to have the outlet replaced. Do not defeat the 
safety purpose of the grounding type plug.  
 
4.6 Ventilation  
Slots and vents in the projector provide ventilation. Never block or cover these openings. This insures reliable 
operation of the projector and prevents overheating.  
All REF series projectors include external fan assemblies and cooling duct work.  Insure these are properly installed 
and operational by your Wolf Cinema specialists.  Never kink or otherwise obstruct air flow to/from the projector. 
• 
Do not place the projector over a radiator or heat register.  
• 
Do not insert objects into the ventilation openings of the projector. They may touch dangerous voltages 
or short out components resulting in a fire or shock hazard. Do not spill liquids of any kind into the projector. 
Should an accidental spill occur, immediately unplug the projector and have it serviced by a qualified service 
technician. 
 
4.7 Replacing Batteries  
The IR remote requires 2 AA size, 1.5V batteries 
(preferably alkaline). To install new batteries:  
1.  Open the battery compartment at the backside of 
the remote by placing your thumb/finger in the oval 
depression and sliding the cover out about 1/2 inch. 
Remote the old batteries and properly discard. Wait a 
minute or two.  
2.  Place the new batteries in the compartment, orienting    the positive/negative of each battery according to the 
labels in the compartment.  
3.  When the batteries are in place, replace the cover by placing the cover 1/2 inch from its closed position and 
slide   it into place. NOTE: Do not force the cover closed. 
 
4.8 Servicing Requirements  
If any of the following conditions exist, immediately unplug the projector from the power outlet and refer service 
to Wolf Cinema accredited service personnel.  
• 
The power cord has been damaged  
 
79 

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ref-1000

Table of Contents