Wolf cinema REF-700 Owner's Manual page 40

Home theater projectors
Table of Contents

Advertisement

NOTE: The Channel key may display a channel list or not, depending on what you have defined for "Display 
Channel List" (see also Menu Preferences in this section). In order to access channels by using Channel on the 
keypad, you must first create the channels.  The Wolf Cinema team will typically deliver the projector with 5‐8 pre‐
set channels for your use. 
 
Creating a New Channel  "AUTOMATICALLY" 
 
To use a new source with the projector, a new channel must be added to projector memory so that the projector 
will respond properly to an input signal from that source in the future. A new channel can be created 
automatically, as described here, or it can be copied from an existing channel and then edited as necessary (see 
Copying or Deleting Channels later in this section). 
 
When you select a direct input ( ex: Input 1), any existing channel memories in the projector are searched for 
matching input and signal parameters – this only occurs if Auto Source is enabled on these channels. If no match to 
the incoming input signal is found in currently‐defined channels, a new channel is temporarily created based on 
factory‐defined defaults for this type of signal. The channel number assigned is the lowest available number from 
01‐50. 
 
NOTES:  1) An automatic channel will be discarded unless one or more of its parameters are changed and will not 
appear in the channel list (see below). 2) If two channels have the same distinguishing source characteristics 
except for the reversal of sync connectors (i.e., H‐sync and V‐sync, are switched), they are still defined as distinct 
channels. 3) You cannot define a new channel without an incoming signal. If the incoming signal does match an 
existing channel, the image will be set up and displayed as usual according to the parameters currently defined for 
that channel. 
 
USING A CHANNEL:  You can normally select a channel at any 
time by pressing the Channel button and select ENTER, or 
enter its number as shown at right. If you want to prevent a 
channel from appearing in this list, you must edit the channel 
as described in Channel Edit later in this section.  
 
NOTES: 1) The current channel is highlighted upon entering the channel list, or, if this channel is not displayed 
here, the first channel in the list is highlighted. 2) Channels created automatically do not appear in the channel list 
unless a parameter for the channel has been changed. 
 
CHANNEL SETUP MENU:  All available channels are listed in the Channel Setup menu, which describes how each 
channel can be accessed and which serves as the gateway for editing, copying and deleting channels.  Press Menu 
from the presentation level to display the Main menu. To display the Channel Setup menu, press 3 , or move the 
highlight to the Channel Setup option and press ENTER . The Channel Setup menu will appear (see sample below), 
with the active channel highlighted. 
 
 
 
 
40 
 

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ref-1000

Table of Contents