Table of Contents
Advertisement
1. Check lamp power through the remote keypad checking the Lamp menu or from the web user interface
Advanced: Lamp menu. Try increasing lamp power.
2. Replace the lamp.
5.3 LCD
5.3.1 Blank Screen, No Menu Displaying
1. Press any arrow key on the built‐in keypad. The backlight on the LCD and the backlight for the built‐in keypad
should turn on. If the LCD is still blank, restart the projector.
5.4 Remote Keypad
5.4.1 Remote Keypad Does Not Seem to Work
1. Replace the batteries.
2. Check if IR signals are received by the projector. Pressing any key on the remote control towards the front or
rear sensor, the Status LED will blink, regardless if any command is executed. If the LED does not blink, restart the
projector.
3. Insure the remote keypad is enabled. If the projector is powered, using the built‐in keypad, open the OSD menu
and go to the Main Menu>Configuration>Communication submenu and check the check boxes for Front IR Enabled
and Rear IR Enabled are checked. Enable them if they were disabled and try again.
4. Projector is busy. If the projector is busy in a warm‐up mode or in a cool‐down mode, the commands from the
remote keypad may be ignored. Wait until the projector reaches a stable state (Power ON or Stand By) and try
again.
5. Press the PROJ key on the remote keypad. If this brings up a pop‐up box on the OSD, insure that the check box
is marked to enable the projector.
6. Using the XLR connector, use the remote as a "wired" keypad. If it does work and all the IR sensors have been
enabled, then there may be a problem with the IR sensors.
5.5 OSD
5.5.1 The OSD Menu does not display
1. Using the LCD, insure that OSD menu is enabled, scroll‐down until the item OSD appears. The LCD shows "OSD:
off". Press and hold the OSD soft key on the built‐in keypad. The LCD now shows "OSD on" then press the menu
key on the remote keypad.
OR
82
Advertisement
Table of Contents
