Wolf cinema REF-700 Owner's Manual page 60

NOTES: 1) There is a centerline (both horizontal and vertical) in the Black Edge Blending test pattern. The
intersection of these lines is the true center of the projector's display area. 2) Adjust white levels before adjusting
black levels.3) Blinders are recommended for fixed installations.
Default Color Adjustments
Refer to System Configuration – Geometry and Color, Color Adjustments by X,Y for description.
Lens VariScope™ (LVS™)
LVS™ provides the ability to recall focus and zoom settings specific to each source input. Custom lens settings
you've chosen for any source will be quickly and accurately applied when you select a source that has already been
calibrated. Place a checkmark in the checkbox to enable LVS™. If no calibration has previously been done you may
be prompted to do a full calibration. If a motion calibration has been done, you will be prompted to complete a
reference calibration. If both calibrations have been done, the checkbox will be checked and LVS™ enabled. If LVS™
is enabled, a reference calibration will be done on power up and the lens will return to the saved position of the
source that is active at the time of power up or to the position the lens was located when it was powered on.
Further adjustments to the zoom, focus and position will be automatically saved for source the selected source. If
you switch to a source with different lens settings and switch back, the lens will automatically move to your saved
settings upon return. Other sources can be used without using LVS™ .
NOTES: 1) See System Configuration – Diagnostics/Calibration, LVS Calibration for further details about calibration.
2) LVS™ control is a preference setting and will be retained between power cycles.
DIAGNOSTICS/CALIBRATION
Test Pattern
Choose the desired internal test pattern to display, or
select OFF to turn off a test pattern. Alternatively, use
the Test key for cycling through test patterns. NOTE:
There is a centerline (both horizontal and vertical) in
the Edge Blending test pattern. The intersection of
these lines is the true center of the projector's display
area.
Test Pattern Grey Level
Set the desired level of grey for displaying in the full gray field test pattern.
Freeze Image
Enter a check mark to freeze (stop) an image on a single frame. This diagnostic tool is useful if you need to examine
in detail a still version of an incoming image that cannot be "frozen" at the source. For example, in moving images
60