Table of Contents
Advertisement
2. Align the lens interface plate with the lens mount. Align the lens electrical connector with the mating connector
on the lens mount. Fully insert the assembly straight into the lens mount opening without turning. Press using your
hand as shown in Figure 2‐4. NOTE: When installing the lens, insure that the lens is not inserted at an angle, as
this can cause damage.
Figure 2.4
3. While holding the lens flat against the lens mount, rotate the lens clamp clockwise to lock the lens assembly in
place. See Figure 2‐5.
Figure 2.5
4. Remove the front lens cap.
5. For added stability,
fasten the security screws
provided with the lens‐
mount. See Figure 2‐6.
Figure 2.6
6. Use a 5mm hex driver to fasten the red security screws provided with the lens mount (Figure 2‐6). 45:+9 __
Recommended for heaviest lenses such as 0.73:1 and 1.2:1. IMPORTANT: The red security screws MUST be
installed when hoisting the projector overhead, or installing the projector in an overhead position.
Figure 2.3
13
Advertisement
Table of Contents
