Table of Contents
Advertisement
Fade Time
Set how long (in seconds) it takes to gradually dissolve one image into another for a source switch when Image
Optimization is set to Smooth Switching. NOTE: PIP must be disabled for Fade Time to take effect. Also, the PIP
window must be closed to activate it.
Numbers Select Main Image
Use Numbers Select Main Image to use the
numeric keys #1‐8 as input keys. This remapping
of the keypad (see right) can be particularly useful
with PIP displays, providing a convenient shortcut
for changing the primary (background) image
without first having to return to the Main menu.
Select "Always" to use the keys in this manner all of the time, even with single displays. For normal keypad
function, select Never (default). Set to When PIP Active to activate number keys only when PIP is in use. NOTE:
Numbers Select Main Image keypad functionality works only when menus are closed.
The Cermax® Xenon Lamp
Whenever you install a new lamp in the projector, access the
Lamp menu to record the lamp serial number in the
projector's memory. You can also choose a lamp mode for
regulating power and light output, change Iris size, and access
other read only information pertaining to past and present
lamps.
LAMP HOURS (read‐only) shows the number of hours logged
on the current lamp. Whenever you record a new lamp serial
number this value automatically resets to "0", where it begins
to log time for the new lamp. This information also appears in
the Information menu.
LAMP S/N (read‐only) is the serial number recorded for the current lamp. When you install a new lamp and enter
its serial number, the number will appear here. Enter a checkmark for LAMP MESSAGE to enable a warning
message that will appear upon power‐up when the lamp has reached the specified lamp limit and should be
replaced. Delete the checkmark to prevent display of this message — instead, when your lamp expires, only the
status display messages on the back of the projector will provide the visual warning to replace the lamp.
NOTES: 1) It is recommended that the Lamp Message checkbox remain enabled. 2) When a lamp warning message
appears, press Exit to temporarily cancel the message. The message will continue to appear upon power‐up until
you install a new lamp.
Set LAMP LIMIT to the number of hours you expect to log on the current lamp before replacing it. This will trigger
a lamp message on‐screen (if enabled). NOTES: 1) If you change modes over the life of a lamp, the lamp limit you
originally expected may no longer be possible. 2) Turning the lamp on and off reduces lamp life significantly, as do
65
Advertisement
Table of Contents
