Table of Contents
Advertisement
For best results, use a good test pattern such as a smooth gray consisting of a clear pattern of black and white
pixels, or a similar "half on, half off" graphic image, such as the Windows shutdown screen. Adjust the slidebar
until the image stabilizes and each pixel is clearly defined. You may notice that you can stabilize the image at more
than one point — i.e., you may find that the image appearance at "11" is identical to the image appearance at
"38", thus you can use either setting. If some shimmer from a video or HDTV source persists, use the "Filter"
control to remove high frequency noise from the signal. See Picture Adjustments.
H‐Position
This option moves the image right or left within the area of available pixels. NOTE: The value shown represents
where the approximate center of the image lies in relation to the total number of pixels available horizontally. This
varies widely according to the signal — watch the image while adjusting.
V‐Position
This option moves the image up or down within the area of available pixels. NOTE: The value shown represents
where the approximate center of the image lies in relation to the total number of pixels available vertically. This
varies widely according to the signal — watch the image while adjusting.
Advanced Size and Position — SUBMENU
This submenu consists of the following options:
ACTIVE INPUT WINDOW: This read‐only value indicates
the current size (i.e., area) of your displayed data or
"region of interest" as defined by the blanking controls.
By default, the projector automatically determines what portion of its full resolution to use, and pixels in the
surrounding borders are turned off. You can also specify a specific active input window size by adjusting one or
more "Blank" settings. For example, if you have blanked (cropped) 100 pixels from both the left and right edges of
an incoming source of 1920 x 1080, the remaining active input
window will be reduced to 1720 x 1080.
BLANKING (TOP, BOTTOM, LEFT, and RIGHT): Crop the image as
desired so that unwanted edges are removed from the display
(changed to black—see right). Blanking defines the size of the
Active Input Window, or area of interest. Range of adjustment
depends on the source resolution and other factors. After
adjustment of blanking it may be necessary to perform a source
switch.
NOTE: Blanking a PIP image resembles zoom. For example, left Blanking zooms the right side of the PIP image;
Right Blanking zooms the left side. There are no black bars.
PLUG & DISPLAY (EDID): EDID = Extended Display Identification Data
standard.
46
Advertisement
Table of Contents
