Panel Settings; Low Power Timer - Xerox Phaser 5335 User Manual

[Panel Settings]

Setting Item
Panel Lock
Change Password
Note
• If you have forgotten the password, switch the printer off and restore the password to the default.
1) Switch the printer on while holding down the
"Reset Password. Reset?" appears on the control panel.
2) Release the
3) Press the <
The password is restored to the default.

[Low Power Timer]

Setting Item
Low Power Timer
96
5 Control Panel Menus
System Settings
Panel Settings
Sets a password to control access to the menus.
• [Off] (default)
• [On]
Allows you to change the password. Enter a new password (4-digit number).
The password takes effect when the first and second entries match. (default:
[0000])
Note
• [Change Password] is valid only if [Panel Lock] is set to [On].
• If the first and second entries do not match, your new password will not be
accepted.
<Menu> button and press the
> button to select [Yes], and then press the
System Settings
Low Power Timer
Sets the amount of time before the printer enters the Low Power mode. Specify
the value in 1 minute increments. (See *2 on P. 111.)
• [1 Minutes] to [60 Minutes] (default: [3 Minutes])
Refer to
• "2.4 Setting/Exiting the Power Saver Modes" (P. 27)
• "Setting Example: Changing the Power Saver Mode Setting" (P. 76)
Panel Settings
Panel Lock
Panel Settings
Change Password
Description
<Menu> button. Keep holding down the button until
<OK/Eject> button.
<OK/Eject> button.
Description