Sleep Mode - Xerox Phaser 5335 User Manual

[Sleep Mode]

System Settings
Sleep Mode
Setting Item
Sleep Mode
[Sleep Mode Timer]
System Settings
Sleep Mode Timer
Setting Item
Sleep Mode Timer
[Time-out]
System Settings
Time-out
Setting Item
Time-out
Consumes less electricity than the Low Power mode. Set whether or not to
enable this feature.
• [Enable] (default)
• [Disable]
Refer to
• "2.4 Setting/Exiting the Power Saver Modes" (P. 27)
• "Setting Example: Changing the Power Saver Mode Setting" (P. 76)
Sets the amount of time before the printer enters the Sleep mode from the Low
Power mode. Specify the value in 1 minute increments. (See *2 on P. 111.)
• [1 Minutes] to [120 Minutes] (default: [5 Minutes])
Note
• This setting is valid only if [Sleep Mode] is set to [Enable].
Refer to
• "2.4 Setting/Exiting the Power Saver Modes" (P. 27)
• "Setting Example: Changing the Power Saver Mode Setting" (P. 76)
Sets the amount of time the printer waits for a print job. If a time-out occurs dur-
ing data reception, the printer stops the reception and prints the data that has
been received.
Specify the time-out value in 1 second increments.
• [Off]
Disables the time-out function.
• [5 Seconds] to [300 Seconds] (default: [30 Seconds])
Description
Description
Description
5.2 Setting the Common Menus
97