Page 1
INSTRUCTIONS FOR REFILLING XEROX PHASER 7500 SERIES The toner cartridge is basically a plastic tube - containing toner and a chip. The cartridge can be refilled as many times as you want. Before you begin Please read instructions from start to finish, before you start your refill.
Page 2
www.zinetic.co.uk Locate the small plastic cover that covers the toner port. Note the orientation of the plastic cover. The refill hole is hidden behind the plastic cover. Slide off the plastic cover that covers the toner refill hole. The plastic cover is on rails and is a tight fit so take your time don’t break it –...
Page 3
www.zinetic.co.uk Remove cap and seal. Fit the toner pouring Shake your bottle spout securely to of new toner the bottle. vigorously for 20 seconds BEFORE Screw it down as removing the cap. tight as it will go. Wrap any type of tape around the base of the spout &...
Page 4
www.zinetic.co.uk It can help to very gently squeeze the bottle with minimum pressure – i.e. the same pressure you would check the ripeness of a piece of soft fruit like a banana. This helps keep the toner moving. If you squeeze the bottle too hard you will get toner powder escaping from the cartridge and landing on the floor.
Page 5
www.zinetic.co.uk 2. We need to release and remove the chip without breaking the plastic clips. Shown opposite. The clips can be depressed from the front - or you can go in from behind and release them. Or a combination of both. 3.
Page 6
www.zinetic.co.uk Refit the new chip. Slide the chip into place. The clips will probably reengage to lock it into place but if they don’t manuvere them into place from behind so that they lock it into place. The chip should be securely locked in place. You can refill this cartridge as many times as you want.