Table of Contents
Advertisement
DCP-XML REMOTE CONTROL
DCP-XML permits remote control of SPLITMUX-DVI-4 by a computer or other devices using the RS-232 serial
port of SPLITMUX-DVI-4. To connect to this port, use the "serial cable" (NTI RJ45-DB9 adaptor + standard RJ45
CAT5 cable).
DCP is an XML-based protocol.
Using DCP, all important settings of SPLITMUX-DVI-4 can be queried and changed.
A general description of XML can be found at http://www.w3.org/XML/
The XML scheme for DCP can be found on the enclosed CD, under the name "dcp.xsd".
For a detailed description on how to use DCP-XML with SPLITMUX-DVI-4 please see the "DCP-XML Manual"
on CD supplied with SPLITMUX-DVI-4.
DCP Modes
DCP has two modes of operation:
1. Control
This mode is intended for direct control of a SPLITMUX-DVI-4, for example using a computer.
2. Synchronize
This mode is used to synchronize multiple, linked devices.
In Synchronize mode, SPLITMUX-DVI-4 sends all settings changes as DCP messages.
Thus, a chain of linked SPLITMUX-DVI-4 can be controlled synchroneously.
SPLITMUX-DVI-4 - Installation and Operation Manual
ANNEX
71
Advertisement
Table of Contents
