Switching Mode - Network Technologies SPLITMUX-DVI-4 Installation And Operation Manual

OSD - USB DEVICE 1-4 - SWITChING MODE
USB Device 1-4 (continued)

Switching mode:

By default, switching mode is „manual switching with warning".
To change the switching mode use the arrow keys to navigate to „CHANGE SWITCHING MODE" and press
ENTER/SELECT.
Use arrow keys to chose one of the following modes to change the switching mode:
1. Manual switching with warning: This mode allows switching the USB port manually by selecting one of the
computers connected. But before executing the switching the following warning message is displayed: „In order
to prevent data loss, stop the USB device before switching!" To execute the switching press ENTER/SELECT.
This switching mode is recommended for USB devices with risk of data loss (e.g. USB stick, printer, external
memory)
2. Manual switching without warning: This mode allows switching the USB port manually by selecting one of
the computers connected. The switching is executed immediately.
This switching mode is recommended for USB devices without risk of data loss.
3. Automatically with active channel: In this mode, the USB device/port is always switched automatically with
the active channel. When switching channel/computer this USB device/port will automatically be switched to the
activated channel/computer.
Note:
After power on, all USB devices are disconnected from computers except devices with switching
mode "automatically with active channel".
SPLITMUX-DVI-4 - Installation and Operation Manual
ON SCREEN DISPLAY
51