Table of Contents
Advertisement
INSTALLATION
CONNECTING SOURCES / COMPUTERS
- Switch off the computer and disconnect keyboard, monitor and mouse.
- Connect keyboard and mouse to the computer ports either with a single USB cable or via the PS/2
interface (use the Y cable) up to 5 meters. For greater distances use a kVM or USB extender.
- To connect an analog video / computer source (VGA) to SPLITMUX-DVI-4, use a VGA-DVI cable.
Digital video sources are connected via a DVI cable up to 20 meters. For greater distances use a DVI or VGA
extender.
CONNECTING USB DEVICES
Connect your USB device to one of the four transparent USB ports to use it with computers connected to
SPLITMUX-DVI-4. It supports transparent USB devices such as printer, external memory, 3D mouse, and finger
printer.
(Configuration see page 50)
POWERING UP ThE SYSTEM
-
Switch on SPLITMUX-DVI-4 with the power switch on the rear panel. All front panel LEDs light up briefly
indicating that SPLITMUX-DVI-4 is ready for operation. SPLITMUX-DVI-4 is now in Quad mode (default).
-
Power up all connected computers. SPLITMUX-DVI-4 recognizes all input video sources automatically and
displays them on your monitor screen.
-
To select another display mode, use the relevant keyboard commands (see page 65) or buttons on the front
panel (page 6).
SPLITMUX-DVI-4 - Installation and Operation Manual
INSTALLATION
Connect USB-Devices
e.g. Printer, USB-Stick, ...
11
Advertisement
Table of Contents
