Table of Contents
Advertisement
ANNEX
SERIAL CABLE
For serial remote control, SPLITMUX-DVI-4 requires a special adaptor to connect a CAT5 cable to the serial
RJ45 port at the rear panel of SPLITMUX-DVI-4.
This adaptor is connected to your external serial control device (e.g. computer). To the adaptor any CAT5 patch
cable (wired straight-through) can be connected. The CAT5 cable again is connected to the RJ45 port of SPLITMUX-DVI-4.
The adaptor (plus a standard CAT5 cable (in green)) always is delivered with SPLITMUX-DVI-4.
Serial cable = NTI adaptor + standard CAT5 cable
70
SPLITMUX-DVI-4 - Installation and Operation Manual
Advertisement
Table of Contents
