Table of Contents
Advertisement
OSD - SYSTEM - SECURITY
Note:
Before changing the security level, please set the configuration you wish to work with to the higher
security level, under MODE
SPLITMUX-DVI-4 is reset, in case of power failure, or when power is turned off and on again.
SECURITY LEVEL 8
Security level 8 allows you to work only on one channel (computer) in a predefined display mode (Quad,
Fullscreen or PiP mode). No settings can be changed, apart from the SECURITY menu item, where you can
change the security level.
SYSTEM
SECURITY
SECURITY LEVEL 7
As security level 8, but you can open OSD windows that only show display modes and device settings.
CONSOLE
VIDEO OUTPUT/EDID
VIDEO
INPUT STATUS
COMPUTER
kEYBOARD/MOUSE/EDID/DDC
HELP
HOTkEY/ABOUT/CONTACT
SECURITY LEVEL 6
As security level 7, with the following additional operations:
SYSTEM
CONTROL
CONSOLE
FADE
- Setting of active channel using front panel buttons, hotkeys or hotmouse
- Selecting channel with PiP button in Quad mode
- Changing the directly selectable PiP channel in PiP mode single direct
SECURITY LEVEL 5
As security level 6, with the following additional operations:
- Setting of display mode (Quad / Fullscreen / PiP) using front panel buttons, hotkeys or hotmouse.
SYSTEM
TEST PATTERN
SPLITMUX-DVI-4 - Installation and Operation Manual
START (see page 31). This configuration will be maintained when
u
ON SCREEN DISPLAY
19
Advertisement
Table of Contents
