Table of Contents
Advertisement
hARDWARE
FRONT PANEL
The SPLITMUX-DVI-4 front panel has seven status indicators (LEDs) and seven buttons.
Buttons 1 to 4 switch between channels, LEDs 1 to 4 indicate the status of the individual channels. Full, Quad
and PiP buttons and LEDs are used to switch and indicate display modes and other functions, e.g. open the
OSD menu etc.
Indicators
- LEDs 1 to 4:
- LED Full:
- LED Quad:
- LED PiP:
Note:
While the OSD menu is open, the active computer can still be operated by mouse.
SPLITMUX-DVI-4 - Installation and Operation Manual
Status LEDs
Buttons
When these LEDs light up green, the corresponding channel (computer port) has
been selected and is available for keyboard and mouse access. When a LED flashes
green, there is no signal at the video input of the selected channel.
An LED lights up yellow when there is a signal at the video input, but another channel
has been selected.
When the LED is dark, there is no signal at the video input and another channel has
been selected.
This LED lights up green when the Fullscreen mode is selected.
When this LED lights up green, the unit is in Quad mode.
This LED lights up green when the PiP function is enabled.
INTRODUCTION
Front panel
5
Advertisement
Table of Contents
