Table of Contents
Advertisement
ON SCREEN DISPLAY
OSD - SYSTEM - CONTROL
Example of DCP control
A SPLITMUX-DVI-4 is controlled via
DCP-XML by a computer connected
by serial cable.
For an introduction to the DEVICE CONTROL PROTOCOL please see page 71 in Annex.
DCP synchronize
Use this mode to keep several SPLITMUX-DVI-4 devices
in the same mode.
Every change in settings initiated in the first switch
by
synchronizes the modes of all connected devices via
DCP messages.
Special serial Y cables are used for this purpose
(see example on page 70)
Important:
Each time you restart a SPLITMUX-DVI-4 set to synchronize, it will send all its settings to the next
connected device. This process also takes place after activating synchronize in the OSD menu.
When starting a chain of devices, always start by first switching on the device at the end of the chain.
When the device has completed its startup phase and sent its DCP messages, switch on the next device
in the chain.
Finally, switch on the first device in the chain, which synchronizes the settings of all other devices in the
chain with its own settings as it starts up.
24
SPLITMUX-DVI-4 - Installation and Operation Manual
hotkeys,
hotmouse,
Front panel buttons, or
a controlling device
Advertisement
Table of Contents
