Side Brush Cleaning; Side Brush Replacement; Driving Wheel Cleaning; Up-Ground Height Sensor Cleaning - ECOVACS Deebot D58 User Manual

Side brush cleaning

Replace sidebrush
Please remove the screws,
and take out the side brush.

Driving wheel cleaning

Up-ground height sensor cleaning

Up-ground height sensor
24
Side brush is a kind of easy wear part. We suggest you to check it every time it
takes cleaning task. Please change it if necessary.
Note：
The host will alarm when the side brush tangles and it will show on LCD as
.
Please replace the side brush when it is destroyed.
Please push the new side brush
into the correct position.
Use roll brush to remove the dust or hair on driving wheel.
Note:
If the wheel is tangled by hair or cloth, the host will alarm and it will show
on LCD as .
Up-ground height sensor is on the front bottom of robot. It can detect the
height difference within 8 centimeters. We suggest you to wipe the optical
board with dry cotton cloth after it finishes task to prevent the dust piling on it
which would affect its performance.
1. Turn off the power and remove the trash inside dust box.
2. Invert the robot, then put it on the even and clean platform.
3. Use dry cotton cloth to wipe three pieces of optical board of up-
ground height sensor.
Tight the screws.