Automatic Charging; Appointment Timing; Set Appointment Time - ECOVACS Deebot D58 User Manual

7 . Automatically Charging
？
strait room
?
strait room

8. Appointment Timing

Appointment Time Setting
First time setting
Tips :
Selection scope: hour is between 0 and 23, minute is
between 0-59.
Under normal circumstance, time display on LCD shows
current time.
●
When it finishes cleaning or there is low battery, it would seek charger
in same route as automatic cleaning.To make it easy for robot to
search for charging block, you need to put the block back to the wall
and make sure there is no obstacle within 1.5 meters ahead of the
infrared receiver. Check carefully whether there is strong reflector in
front of the charger, such as ground glass, smooth ceramic vase and
so on.
●
It takes time for robot to seek the charger. The reserve time differs from
the ground situation.
●
Robot can return to the charger if the ground situation is not too
complicated. Under extreme circumstance, such as, huge house and
complex layout would probably bring difficulty for robot to seek for
charger. In such case, you should help to put the robot back to charger.
●
Take care of the first automatic charging, if you find that the robot keeps
turning in the certain area after trying several times to seek back, you
can help to place it on the charger and look through the charging.
●
Under mode, main brush will stop working and robot cannot do the
cleaning.
●
Robot shall stay at the charger when it finishes charging and it transfer
to small currency to charge until you start operating. If you have set
appointment timing cleaning, it would go out of the charger to do
cleaning when it comes to appointment time.
1. After power is on, keep press
around 3 seconds then
and the number with time setting is
flashing.
mode
2. Set hour and minute via
time press
.
minute
minute for
3. When you finish setting time, press
mode
again, and then go to second time setting
For example:
Set current time
as 12:07 pm,time
display on LCD
should be:
E n j o y S m a r t e r L i f e !
on LCD is light
and
will increase one hour or
While decrease one hour and
.
for
,
each
.
15