Border Cleaning Mode; Fixed Point Cleaning Mode; Intensive Cleaning Mode; Go Back Charging Mode - ECOVACS Deebot D58 User Manual

Border Cleaning Mode

Fixed Point Cleaning Mode

Intensive Cleaning Mode

Go Back Charging Mode

14
Route description: under this mode, once the robot detects objects, it
would run along it, like wall, to clean until it meets obstacle and change
the former route.
Under this status, robot helps to remove the corner of wall, table,
sofa and bed where it is beyond the mode of automatic cleaning.
The operation of this mode takes around 25 minutes and then robot
goes back to charging block by itself.
Route description: under this mode, robot runs from inside out shaping
spiral and focuses on the certain point to clean for one time. The
cleaning coverage is a round shape with diameter of 1.2 meter.
This mode is applicable to certain area with plenty of dust.
Under common circumstance, the cycle of one fixed point cleaning
takes not more than 6
meets obstacle or detects staircase, it would shift to avoid
obstacle and staircase to turn back to work under this status.
Robot shall stay where it stops and give tip music after finishing.
Route description: under this mode, robot takes the same route as
automatic cleaning. It would search for charging block by itself before it
runs of battery.
Under the same ground circumstance, the cleaning effect is the
best .
If the ground is quite dirty, we recommend this mode
Route description: robot will search for charging block automatically when
it detects low battery, what's more, green light flashed once the charger
is connected.
minutes. During operation, if robot continually
.