Dust Box And Sponge Filter; Cleaning The Robot's Dust Sensor And Drop Sensor - ECOVACS DEEBOT D77 Instruction Manual

4.3 Dust Box and Sponge Filter

Cleaning the robot's Dust Box and Sponge Filter.
4.4 Cleaning the Robot's Dust Sensors and Drop Sensors
Location
Drop Sensors are located on the bottom of
the robot.
Function Detects a drop-off of over 3 inches.
1. Turn off the power and empty the dust
box.
2. Invert the robot then put it on an even,
Cleaning Method clean surface.
3. Use a clean dry cloth to wipe the three
panels of the Drop Sensors.
Turn the robot's power
OFF and open the cover.
Open the dust box cover,
empty it, and remove the
filter components. Unfold
the bracket, and clean
and/or replace filter.
If you notice a lot of dust build-up on the inside of the dust box and sponge filter
that cannot be removed using the method described in section 4.3, you can rinse
the box and sponge under running water to get rid of the dust. It is important that
you allow them to completely dry for 24 hours before reinstalling into the robot.
Drop Sensors
Drop Sensors
Grasp the handle of the dust
box. Slowly and carefully
remove the dust box to avoid
spilling dust.
After cleaning and/or replacing
the filter, close the filter cover
and ensure you hear it click
closed. Place the dust box
back into the robot and close
the cover.
Dust Sensors
Dust Sensors are located in front of robot's
dust box.
Detects dust quantity to determine the
most effective cleaning mode.
1. Turn off power.
2. Empty the dust box and clean it if
necessary.
3. Use a clean dry cloth to wipe the two
Dust Sensors.
Dust Sensors
14