Graphics Interface
The display port consists of the following:
•
1 DVI-I port
DVI-I
DVI-I Port
The DVI-I port is used to connect an LCD monitor.
Connect the display device's cable connector to the DVI-I port. After plugging the cable con-
nector into the port, gently tighten the cable screws to hold the connector in place.
BIOS Setting
Configure the display devices in the Chipset menu ("System Agent Configuration" submenu) of
the BIOS. Refer to the chapter 7 for more information.
Chapter 5 Ports and Connectors
Chapter 5
RJ45 LAN Ports
LAN 1
LAN 2
LAN 1
LAN 2
Features
•
Two Intel
I210AT PCI Express Gigabit Ethernet controllers
®
The two LAN ports allow the system board to connect to a local area network by means of a
network hub.
BIOS Setting
Configure the onboard LAN ports in the Chipset menu ("PCH-IO Configuration" submenu) of
the BIOS. Refer to the chapter 7 for more information.
Driver Installation
Install the LAN drivers. Refer to the chapter 8 for more information.
25
www.dfi .com