AXIOMTEK SBC84833 Series User Manual page 60

SBC84833 Series All-In-One Capa Board User's Manual
Video Power Down Mode
This option specifies the Power State. When the BIOS places it in a
power saving state, the video subsystem enters when the BIOS
places it in a power saving state after the specified period of display
inactivity has expired. The default setting is Suspend.
Disabled
Suspend
Hard Disk Drive Power Down Mode
This option specifies the power conserving state that the hard disk
drive enters after the specified period of hard drive inactivity has
expired. The default setting is Suspend.
Disabled
Suspend
Suspend Time Out (Minute)
This option specifies the length of time the system waits before it
enters suspend mode. The default setting is Disabled.
Disabled
1 Min
4 Min
10 Min
Throttle Slow Clock Ratio
Use this item to specify the speed of the system clock when running
the power saving states.
54
This setting prevents the BIOS from initiating any
power saving modes concerned with the video
display or monitor.
This option places the monitor into suspend mode
after the specified period of display inactivity has
expired. This means the monitor is not off. The
screen will appear blacked out. The standards do
not cite specific power ratings because they vary
from monitor to monitor, but this setting use less
power than Standby mode. This is the default
setting.
This setting prevents hard disk drive power down
mode.
This option cuts the power to the hard disk drives
during a system suspend. This is the default
setting.
This setting prevents the system from entering
suspend mode. This is the default setting.
Set this item to allow the computer system to enter
suspend mode after being inactive for 1 minute.
Set this item to allow the computer system to enter
suspend mode after being inactive for 4 minutes.
Set this item to allow the computer system to enter
suspend mode after being inactive for 10 minutes.
AMI BIOS SETUP UTILITY