Error Messages - Neopost Printer 830 User Manual

7.2

Error Messages

Error Messages
NO PAPER !!
PAPER JAM OR
WRONG PAPER LENGTH!
NO INK !!
CHANGE CARTRIDGE
CHECKSUM ERROR!
MAKE DEFAULT RESET
CHECKSUM ERROR!
MAKE COUNTER RESET
CHECKSUM ERROR!
TESTMACRO RESET
CHECKSUM ERROR!
SETTING RESET
CHECKSUM ERROR!
RESET PENVALUES
TEST MACRO TOO LONG
BUFFER OVERFLOW !!
RAM ERROR !!
VERIFY RAM
UNPRINTED ADDESSES!
FINISH THE JOB
PROGRAM ERROR
MAKE DEFAULT RESET
UART TIMEOUT
RESET THE PRINTER!
DISPLAY TIMEOUT
RESET THE PRINTER!
ERROR FPGA Ready
CALL SERVICE
CHECK CARTR.
START TO CONTINUE
PRINTING ERROR
REPEAT LAST ADDRESSES
Reduce Pap. Speed! U#
START to continue!
Feed Motor Jammed!
START to Continue
Feed Motor Controller
Fault! Call Service
Cause
No paper
Paper jam
The cartridge is empty.
Error in the buffered RAM
Error in the buffered RAM
Error in the buffered RAM
Error in the buffered RAM
Error in the buffered RAM
The user-defined test ad-
dress is too long
Overflow of reception
memory.
RAM error on the CPU
board
Address is not completely
printed.
Error in the program flow.
Error in the UART chip or
FET transistor
Error with display con-
trols.
Error FPGA-IC
Cartridge is not inserted
Severe error
Transport speed too high
for the printing unit #
Error with motor control
Fault initializing motor-IC
Remedy
Insert paper
Check paper width
Insert a new cartridge and
reset the counter.
Factory setting
(PROG key)
Default factory setting
(ONLY for technicians)
Factory setting
(PROG key)
Factory setting
(PROG key)
Factory setting
(PROG key)
Be aware of the maximum
length.
Check connection to the
PC.
Replace the CPU board.
Make no changes in the
programming mode while
a print job is in progress!
Factory initialization - re-
load firmware
Replace the CPU board
Switch off printer
Check cable connection
Replace display unit
Replace the board
Insert missing cartridge(s)
Reduce speed or data vol.
Update Flexmail or mailing
software
Remove paper jam
Replace board
63