Enclosure And Rear Panel Features - Extron electronics PowerCage 1600 User Manual

Enclosure and Rear Panel Features

Rear Panel
PowerCage 1600
Power Supply
N15778
1T23
I.T.E.
100-240V 50/60Hz
5A MAX.
1 2
Power Main Slot for
Connector Power Redundant
Supply Power Supply
(standard) (optional)
Figure 3.
a
b
c
d
3
The Rear Panel of the PowerCage 1600 Enclosure
Power connector — Connect this port to a 110-240 VAC, 50-60 Hz power source
using a standard IEC power cord.
NOTE:
The power supplies and transmitter and receiver boards may be installed or
replaced before or after the unit is powered on.
Main power supply — This power supply is included with every PowerCage
enclosure. The front panel
Slot for a redundant power supply — An optional redundant power supply can
be installed in this slot. If this second power supply is installed, the front panel
LEDs indicate its status.
Slots for transmitter and receiver boards — Slots are numbered from 16 to 1
from left to right as viewed from the rear of the unit and shown in the following
diagram:
PowerCage 1600 PowerCage 1600
Power Supply Power Supply
Power Power
16
Supply Supply
1 2
N15778
1T23
I.T.E.
100-240V 50/60Hz
5A MAX.
The front panel board status LED
NOTES:
• Cover all empty board slots; do not leave them open. Securely fasten the
screws for boards and blank panels.
• A double-slot board connects to the lower-numbered slot.
4
Slots for
Transmitter and Receiver Boards
(up to 16 single-slot or
8 double-slot optional boards)
PSU 1 LEDs indicate the status of this power supply.
Slot Numbers
15 14 13 12 11 10 9
numbers correspond to these slot numbers.
PowerCage 1600 Enclosure • Installation
PSU 2
8 7 6 5 4 3 2 1
5