Enclosure And Rear Panel Features - Extron electronics PowerCage 1600 User Manual

Enclosure and Rear Panel Features

WARNING: Potential risk of severe injury. Installation and service must be
AVERTISSEMENT :
Rear Panel
PowerCage 1600
Power Supply
N15778
1T23
I.T.E.
100-240V 50/60Hz
5A MAX.
1 2
Power Main
Connector Power
Supply
(standard)
Figure 3.
1
2
3
4
performed by authorized personnel only.
Risque potentiel de blessure grave ou de mort. L'installation
et l'entretien doivent être effectués par le personnel autorisé uniquement.
3
Slot for
Redundant
Power Supply
(optional)
The Rear Panel of the PowerCage 1600 Enclosure
Power connector — Connect this port to a 110-240 VAC, 50-60 Hz power source
using a standard IEC power cord.
NOTE: The power supplies and transmitter and receiver boards may be installed or
replaced before or after the unit is powered on.
Main power supply — This power supply is included with every PowerCage
enclosure. The front panel PSU 1 LEDs
Slot for a redundant power supply
installed in this slot. If this second power supply is installed, the front panel
indicate its status.
Slots for transmitter and receiver boards
left to right as viewed from the rear of the unit and shown in the following diagram:
PowerCage 1600 PowerCage 1600
Power Supply Power Supply
Power Power 16
Supply Supply
1 2
N15778
1T23
I.T.E.
100-240V 50/60Hz
5A MAX.
Figure 4. PowerCage 1600 Enclosure Slots
4
Slots for
Transmitter and Receiver Boards
(up to 16 single-slot or 8 double-slot
optional boards)
indicate the status of this power supply.
— An optional redundant power supply can be
— Slots are numbered from 16 to 1 from
Slot Numbers
15 14 13 12 11 10 9 8
PowerCage 1600 Enclosure • Installation
PSU 2 LEDs
7 6 5 4 3 2 1
6