Data Error Information (Snn); Changing The Serial Interface Configuration - Kyocera Ecosys FS-6700 Service Manual

Data error information (Snn)

A data error occurred on the serial interface is indicated on the service status page.
The Snn code in the same row as Service information on the status page shows var-
ious error conditions as follows:
Table A. 4 Data errors
S00
S01
S02
S03
S04
S05
S06
S07

Changing the serial interface configuration

To change the serial interface protocol from RS-232C to RS-422A, or vice versa, the
main controller board must be taken out of the printer. Protect the electronics by
taking these precautions:
Caution
Caution
Caution
Refer to chapter 3 and remove the main circuit board out of the printer.
Locate the jumper connector.
To change the serial protocol from RS-232C to RS-422A, for example, carefully
remove the jumper connector from the main circuit board, and reconnect to the pin
position shown in the diagram.
FS-6700
†††.Robust: Xon is sent every 3 to 5 seconds during ready or waiting. Error Control: Sets the printer
off line when an error occurs or at off line state.
S code
No error
Framing error
Overrun error
Overrun error and framing error
Parity error
Parity error and framing error
Parity error and overrun error
Parity error, overrun error, and framing error
Before touching the main circuit board, touch a water pipe or other
large metal object to discharge yourself of static electricity. While
doing the work, it is recommended that you wear an antistatic wrist
strap.
Touch the main circuit board only by the edge.
Be sure to remove the memory card first if inserted in the printer's
memory card slot.
Meaning
A-5