1.5
Installation
Environmental requirements
Environmental conditions
Environmental conditions described in Table 1. 1 on page 3 should be observed to
ensure the optimum operation of the printer. The use of the printer in a location
which does not satisfy the requirements may result in troubles and risk shortening
its service life.
The printer will work best if it is installed in a location that is:
Level and well supported (Place the printer on a sturdy table or desk.)
•
Not exposed to sunlight or other bright light (not next to an uncurtained win-
•
dow). Do not place the printer on an unstable cart, stand, or table.
Near an AC wall outlet, preferably one that can be used for the printer alone
•
(See Table 1. 1 on page 3). (The outlet should have a ground slot, or an adaptor
should be used. If you use an extension cord, the total length of the power cord
plus extension cord should be 17 feet or 5 meters or less.
Well ventilated, not too hot or cold, and not too damp or dry. If you install the
•
printer where the temperature or humidity is outside the requirements in
Table 1. 1 on page 3 in chapter 1, the best print quality may not be expected
and there will be an increased chance of paper jams.
Provide a sufficient clearances around the printer to ensure ventilation and
•
ease of access. See below.
Clearance
Allow the necesary minimum clearance on all sides of the printer (below).
30 cm
60 cm
P R O D U C T
30 cm
1-12
I N F O R M A T I O N
50 cm
25 cm
Installation
FS-6700