Kyocera Ecosys FS-6700 Service Manual page 2

FS-6700 Service Manual
©Kyocera Corporation 1998 All rights reserved. Export Edition
Notice
The information in this manual is
subject to change without notification.
Additional pages may be inserted in
future editions. The user is asked to
excuse any technical inaccuracies or
typographical errors in the present
edition.
No responsibility is assumed if
accidents occur while the user is
following the instructions in this
manual. No responsibility is assumed
for defects in the printer's firmware.
The contents of this manual are
protected by copyright. No part of this
manual may be reproduced or copied
by any means without the permission
of the copyright holder. The printer's
firmware (contents of its read-only
memory) is similarly protected by
copyright.
Trademark Notice
PRESCRIBE is a registered
trademark of Kyocera Corporation.
PRESCRIBE II, KIR, Kyocera Image
Refinement, Ecosys, and Ecotone are
trademarks of Kyocera Corporation.
Diablo 630 is a product of Xerox
Corporation. IBM Proprinter X-24E
is a product of International Business
Machine Corporation. Epson LQ-850
is a product of Seiko Epson
Corporation. HP LaserJet 5Si and
HP-7475A are product of Hewlett-
Packard Company. Hewlett-Packard,
PCL, and HP-GL are registered
trademarks of Hewlett-Packard
Company. Centronics is a trade name
of Centronics Data Computer Corp.
This Kyocera printer uses
PeerlessPrint5 to provide the HP
LaserJet IV compatible PCL5e
language emulation. PeerlessPrint5 is
a trademark of the Peerless Group,
Redondo Beach, CA 90278, U.S.A.
Warning
This equipment has been certified to
comply with the limits for a Class B
computing device, pursuant to
Subpart J of Part 15 of FCC Rules.
Only peripherals (computer
input/output devices, terminals, etc.)
certified to comply with the Class B
limits may be attached to this
equipment. Operation with non-
certified peripherals is likely to result
in interference to radio and TV
reception.
Check that the cable is wired
correctly. If an IBM communication
adapter cable type 1502067 is used, it
will have to be resoldered the wiring
at the printer end of the cable. The
procedure is as follows.