Installing The Fuser Roller - Kyocera Ecosys FS-6700 Service Manual

Remove the four screws
lamp.
Note Do not directly touch on the heater lamp. Finger prints on the heater's
outer surface can prevent proper fusing of toner on paper.
To install a new heater lamp, be sure that the lamp terminal (end)
hitched by the fuser terminal

Installing the fuser roller

Remove the four screws to remove the cover. When lifting the cover, hold the heat
roller so as not to drop the roller.
To remove the heat (metal) roller, first remove "plate fuser up" by using a small
flat-blade screwdriver as shown below.
Note Special care should be taken not to let the screwdriver go too far into
the hole. Such an action can irrevocably damage the roller surface.
Disassembly: Main unit printer
and remove the fuser top cover. Remove the heater
.
5-14
Disassembly
is properly
FS-6700