Kyocera Ecosys FS-6700 Service Manual page 31

Table 6. 5 User-recoverable errors
Indication
Warning low memory
Toner low TK-20/Clean
printer
Replace Toner/Clean printer Replace the toner container using a new toner kit.
Clean printer..Press CON-
TINUECONT
ReplaceWaste- toner bottle
Missing Waste-toner bottle
Memory overflow..Press CON-
TINUECONT
Print overrun..Press CON-
TINUECONT
MEMORY CARD err/Insertagain The memory card is accidentally removed from the
Insert the same MEMORY CARD You have inserted the wrong memory card when the
User-recoverable errors
Corrective action
The printer's internal memory is running low due to
the number of fonts and macros downloaded. Print a
status page to see how much user memory is left,
and try deleting unnecessary fonts and macros. See
the PRESCRIBE II DELF and DELM commands
explanation in the programming manual (CD-ROM).
Replace the toner container using a new toner kit.
See Section
The printer does not operate when this message is
displayed. See section
Please clean the inside of the printer. See Section
...This message will be displayed when replacing the
toner container after the message ReplaceToner-
Cleanprinter has been displayed. After cleaning the
inside of the printer, press the CONTINUECONT
key and the printer will be ready for printing.
Replace the old waste toner bottle with the new one
which is included in the TK-20/TK-20HTK-20G
toner kit. The message will also be shown if the
waste toner bottle has become full. The waste toner
bottle should be replaced when the message display
eventually shows TonerlowTK-20Cleanprinter. See
Section
Install the waste toner bottle. See Section ... The
printer does not operate when this message is dis-
played.
The total amount of data received by the printer
exceeds the printer's internal memory. Try adding
more memory (expansion RAM). Press the CONTIN-
UECONT key to resume printing. You can abandon
printing by the CANCEL key.
The data transferred to the printer was too complex
to print on a page. Press the CONTINUECONT key
to resume printing. (The page may break in some
pages.)You can abandon printing by the CANCEL
key.Note: After this message has been displayed,
Page protect mode will be On. To maintain optimum
use of memory during printing, display >Pagepro-
tect from the control panel, and re-select Auto.See
the printerís userís manual.
printer's memory card slot during reading. If you
continue reading the memory card, insert the same
memory card into the slot again. The printer again
reads it from the beginning of the data.Note: We rec-
ommend that you follow the reading procedure from
the beginning to ensure correct reading of the mem-
ory card.
Insertagain message was displayed. Remove the
wrong memory card from the printer's memory card
slot and insert the correct memory card. The printer
again reads it from the beginning of the data.
6-12
Troubleshooting
FS-6700