Places To Avoid; Notes On Power - Kyocera Ecosys FS-6700 Service Manual

P R O D U C T
Installation

Places to avoid

Avoid installing the printer in locations exposed to:
•
•
•
•
•
•
•
•
•
•

Notes on power

•
•
•
•
•
•
Warning
Wornung
FS-6700
I N F O R M A T I O N
Direct drafts of hot or cold air.
Direct drafts of outside air. (Avoid locations next to outside doors.)
Sudden temperature or humidity changes.
Any source of high heat, such as a radiator or stove.
Excessive dust. Dust and smoke may cause contamination on the laser scanner
window, causing print quality problem.
Vibration.
Ammonia fumes or other harmful fumes. (In case of humigating the room or
saturate it with insecticide, remove the printer first.)
Avoid greenhouse-like rooms. (Because of sunlight and humidity.)
Avoid enclosed spaces that block ventilation.
Avoid sites more than 6500 feet or 2000 meters above sea level.
Use only the power source voltage conforming to the printer's rated power volt-
age (See Table 1. 1 on page 3). Do not use other power sources.
Disconnect the printer from the power source before attempting removal or re-
placement of an electrical component or a printed-circuit board.
The printer should not be connected to a power source until the instruction is
given to do so when performing tests described in this manual.
In connecting the printer power, exercise an extreme care in handling the
power supply or any other electric parts which may give an electric shock.
Before performing maintenance or repair, power from both the power source
and the associated peripheral devices (computer, sorter, etc.) should be discon-
nected, unless otherwise specified.
To avoid possible electrical shock, extreme caution must be exercised in han-
dling the power cord and any other electrical part.
As the disconnect device is not incorporated in the printer's AC pri-
mary circuit, an easily accessible socket outlet must be provided near
the equipment.
Da kein Trennschalter in den Wechselstrom-Primärkreis des Druckers
eingebaut ist, muß eine leicht zugängliche Steckdose in der Nähe des
Gerätes vorhanden sein.
1-13