Dome Camera Setup - Hitachi VK-S454ER User Manual

12.5 Dome Configuration.

13. Dome Camera Setup

13.1 Address / Protocol Coding Switch Drawing
13.2 Address Setup.
As shown in Figure 12, SW1 is used to set address of the dome camera from 1 – 1023. The coding switches from DIP-10 to DIP-1 are
equivalent to a 10-bit binary digital. DIP-10 is MSB while DIP-1 is LSB. The state "ON" of each bit means 1 while "OFF" means 0.
Following table shows states of coding switches of some addresses.
Dome
Address
DIP-1
1 ON
2 OFF
States of Coding Switches
DIP-2 DIP-3 DIP-4
OFF OFF OFF
ON OFF OFF
Figure 14
Figure 15
DIP-5 DIP-6 DIP-7
OFF OFF OFF
OFF OFF OFF
High Speed Dome Camera User's Manual
DIP-8 DIP-9 DIP-10
OFF OFF OFF
OFF OFF OFF
- 37 -